rubber bearing

英 [ˈrʌbə(r) ˈbeərɪŋ] 美 [ˈrʌbər ˈberɪŋ]

网络  橡胶轴承; 隔震器

化学



双语例句

  1. Experimental study on shaking table of model building with rollers and lead rubber bearing Each compartment has two cushioned bunk beds and a desk with a reading lamp on it.
    滚轴与橡胶垫隔震结构模型震动台试验研究列车员:每个包房有两张带软垫的双层床,有书桌和台灯。
  2. When the basement is on fire, such as the role of convection, radiation will make laminated rubber bearing at a high temperature environment with the increasing temperature.
    当地下室发生火灾时,随着温度的升高,对流、辐射等作用会使叠层橡胶支座处在一个高温的环境中。
  3. Experimental Investigation and Analysis of the Aseismatic Behavior of the Serial System of Laminated Rubber Bearing after High Temperature
    高温后叠层橡胶支座串联体系抗震性能试验研究与分析
  4. Experimental Research on A Shaking Table Model with Combinatorial Isolation System Made-up of Rollers and Lead Rubber Bearing
    乳胶海绵座垫和靠背垫滚轴-橡胶垫支座组合隔震体系的模型振动台试验研究
  5. Kinematic model is an issue exists in suspension rigid body does not take into account the deformation of the deformation of rubber bearing gap between the various structures.
    运动学模型中存在的一个问题是未考虑悬架刚体的变形、橡胶支承的变形及各结构之间的间隙。
  6. Application of laminated rubber bearing on house seismic isolation project
    橡胶隔震支座在房屋隔震工程中的应用
  7. Supervision control point of laminated rubber bearing
    板式橡胶支座施工安装的监理控制要点
  8. The experimentations and the practical engineering examples reveal that rubber bearing don't fit warships, especial for conventional submarine.
    试验和工程证明,橡胶轴承并不适用于隐蔽性要求较高的舰艇,特别是常规潜艇。护卫舰撞击了潜艇。
  9. This paper describes development of differential restoring model of lead rubber bearing and its application in seismic-isolation design.
    简要介绍了铅芯隔震橡胶支座微分型恢复力模型的发展过程及其在隔震设计中的应用。
  10. Research on Dynamic Characteristics of Translation-torsion Coupled Vibration Isolation System with Consideration of Bidirectional Nonlinearity of Rubber Bearing Pads H-oscillation Properties of Nonlinear Impulsive Vector Hyperbolic Differential Equations
    考虑橡胶垫双向非线性时平扭耦联隔震结构动力性能的研究非线性脉冲向量双曲型微分方程解的H-振动性
  11. The application of rubber bearing in steel structure corridors
    浅析橡胶支座在钢结构通廊中的应用
  12. Research on Dynamic Characteristics of Translation-torsion Coupled Vibration Isolation System with Consideration of Bidirectional Nonlinearity of Rubber Bearing Pads
    地基土&偏心结构相互作用体系平扭耦联振动特性研究考虑橡胶垫双向非线性时平扭耦联隔震结构动力性能的研究
  13. The Design Method of the Seismically Isolated Bridge by Lead Rubber Bearing Based on Energy Method
    基于能量法的铅芯橡胶支座隔震桥梁设计方法
  14. Therefore, the main topic of this study is to dealing with the seismic behaviors of the skew bridge with rubber bearing.
    本文主旨为探讨装设橡胶支承垫之斜桥,在地震作用下的行为反应。
  15. In this paper, a new aseismic rubber bearing, which was developed recently by the authors, and its properties are described.
    本文简要介绍了作者最近研制的新型减震橡胶支座及其滞回阻尼性能。
  16. High damping rubber bearing is starting to be used in bridge engineering in China.
    目前高阻尼橡胶支座在国内桥梁工程建设中使用尚处于起步阶段。
  17. The Analysis of Laminated Rubber Bearing Tandem Column System Stability
    叠层橡胶支座与柱串联隔震体系稳定性分析
  18. In order to improve the effect of shock absorption and applied scope of base-isolated structure with lead rubber bearing and study its optimum parameter.
    目的为改善铅芯橡胶支座隔震结构的减震效果和适用范围,并确定结构的优化参数和控制装置优化布局。
  19. Effect of soil-structure interaction on lead core rubber bearing isolations structure
    土-结构相互作用对铅芯橡胶支座隔震结构的影响
  20. Small occupation area and stable mechanical properties, and long-enduring rubber bearing with super shock absorption and fine abrasion resistance to be used.
    占地面积小,机械性能稳定。采用橡胶轴承,减震、耐磨效果好,使用寿命长。
  21. The Experimental and Ansys Study on characteristics and Isolator Effect of High Damping rubber bearing
    高阻尼橡胶隔震支座的力学性能及隔震效果分析研究
  22. The analysis is focused on the effects of the storey number of of the rubber, the mass of the intermediate steel plates and the structural parameters of the laminated rubber bearing.
    文章着重考虑了叠层橡胶隔震器的层数,钢板质量以及橡胶层结构参数对叠层橡胶隔震支座的振动传递率的影响。
  23. The elastic hysteresis model and the viscous damping hysteresis model were used for laminated rubber bearing;
    即叠层橡胶支座采用弹性恢复力模型和粘滞阻尼恢复力模型;
  24. In this paper, the dynamic stability of serial system of laminated rubber bearing with column is studied.
    对叠层橡胶支座与地下室柱串联体系动力稳定性进行了研究。
  25. The disk springs are installed on the rubber bearing. The method of determining isolation layer parameter and mechanical models are also given.
    在橡胶隔震支座上串联碟形弹簧,并给出了隔震层参数的确定方法和相应的力学模型。
  26. The static stability of the serial isolation system consisting of laminated rubber bearing and column are introduced.
    介绍了橡胶支座&悬臂柱串联体系的静力稳定公式。
  27. The structure and design essentials of the composite rubber bearing has been introduced.
    组合式橡胶支座的构造和设计要点;
  28. The bracket distortion and the influence of rubber bearing are also considered.
    同时也考虑了支架变形和橡胶支座对整体结构的影响。
  29. The new type of water-lubrication stern tube rubber bearing and the ordinary NBR bearing are compared and analyzed.
    并对新型水润滑橡胶尾轴承和普通丁腈橡胶尾轴承进行了分析和对比。
  30. According to the characteristics of the lead rubber bearing, adopt non-linear connection unit simulated.
    根据铅芯橡胶支座的特性,采用非线性连接单元对其进行模拟。